Description The CC Debugger is a small programmer and debugger for the TI Low Power RF System-on-Chips. It can be used together with IAR Embedded Workbench for 8051 (version 7.51A or later) for debugging and SmartRF Flash Programmer for flash programming. The CC Debugger can also be used for controlling selected devices from SmartRF Studio. Technical Specifications Minimum voltage from target: 1.2 Volt Maximum voltage from target: 3.6 Volt Operating temperature: 0 to 85°C Regulated voltage: 3.3 Volt Maximum target current draw: 200 mA Supported Software IAR Embedded Workbench For C8051 SmartRF Flash Programmer SmartRF Studio SmartRF Packet Sniffer PurePath Wireless Configurator Connects to PC: Via USB interface Connects to target board Target board connection via 10-pin IDC connector (2×5 2.54mm pitch). The figure below shows the header pinout: Supported Devices: CC-Debugger can be used to program and debug the following 8051-based system-on-chips from Texas Instruments: CC1110, CC1111 CC2430, CC2431 CC2510, CC2511 CC2530, CC2531, CC2533 CC2540, CC2541 CC2543, CC2544, CC2545 It is possible to control the same devices from SmartRF Studio. In addition, CC-Debugger can control the following transceivers from SmartRF Studio: CC1120, CC1121, CC1125, CC1175 CC1100, CC1101, CC110L, CC113L, CC115L CC2500, CC2520 It can also be used to program the PurePath Wireless devices: CC8520, CC8521 CC8530, CC8531 Documents and Downloads DN304 – CCxxxx Development Tools USB Driver Installation Guide CC Debugger User’s Guide (Rev. H) CC Debugger Layout and Schematics CC Debugger Quick Start Guide (Rev. B) Package Includes 1x CC Debugger (Made in China) – Tested and QC-OK 1x Mini USB cable 1x 10-pin female-female flat cable with 2×5 2.54mm connector
